Fold-out position of the wipers

Required when changing the wiper blades or under frosty conditions, for example.

1. Switch off the ignition.

2. Under frosty conditions, ensure that the wiper blades are not frozen onto the windshield.

3. Press the wiper lever up beyond the point of resistance and hold it for approx. 3 seconds, until the wiper remains in a nearly vertical position.

After the wipers are folded back down, the wiper system must be reactivated.

Before switching the ignition on, fold the Fold the wipers back down

Before switching the ignition on, fold the wipers back down to the windshield; otherwise, the wipers may become damaged when they are switched on.

1. Switch on the ignition.

2. Press the wiper levers down. The wipers move to their resting position and are ready for operation.

    See also:

    Adaptive fixing system
    The adaptive fixing system is used to divide up the cargo area. It consists of two brackets with a telescopic rail and retaining straps. These are guided into the two rails on the cargo area flo ...

    Switching off the engine
    Procedure 1. Engage transmission position P with the vehicle stopped. 2. Press the Start/Stop button. 3. Set the parking brake. 4. Remove the remote control from the ignition lock Before driv ...

    Tail lamps, bulb replacement
    At a glance 1 Turn signal 2 Backup lamp 3 Inside brake lamp 4 Tail lamp 5 Tail lamp/brake light Turn signal, tail lamp and brake lamp Follow the general instructions on lamps and bulbs. 21- ...