Storing
1. Switch on the ignition.
2. Set the desired position.
3.
Press the button. The LED in
the
button lights up.
4. Press the desired button 1 or 2. The LED goes out.
If the M button is pressed accidentally:
Press the button again. The LED
goes out.
See also:
Malfunction
The yellow warning lamp flashes and
then lights up continuously. A Check
Control message is displayed. No flat
tire can be detected.
Display in the following situations:
A wheel without T ...
Starting destination guidance after
entering the destination
1. "Accept destination"
2. "Start guidance" or "Add as another
destination"
Add, a destination as a
further destination. ...
Washer fluid reservoir
Adding washer fluid
Only add washer fluid when the engine is
cool, and then close the cover completely to
avoid contact between the washer fluid and hot
engine parts.
Otherwise, there is the d ...
