What to do if...
- The current transmission position cannot be
displayed?
The vehicle is located in an unrecognized region, is in a poor reception area, or the system is currently determining the position. Reception is usually best when you have an unobstructed view of the sky. - The destination without street information is
not used for route guidance?
When city has been input, no downtown can be determined.
Input any street in the selected city and start destination guidance. - The destination is not used for route guidance?
The destination data is not contained in the navigation data. Select a destination that is as close as possible to the original. - Letters for destination input cannot be selected?
The stored data do not contain the data of the destination.
Select a goal that is as close as possible to the original. - Is the map displayed in shades of gray?
"Traffic conditions/gray map" Active: indication on the control display is switched to shades of gray. This enables a better view of the traffic bulletins. - Spoken instructions are no longer output
during route guidance in front of intersections?
The area has not yet been fully recorded, or you have left the recommended route and the system requires a few seconds to calculate a new route suggestion.
See also:
Manual transmission
Switching off the engine
1. With the vehicle at a standstill, press the
Start/Stop button.
2. Shift into first gear or reverse.
3. Set the parking brake. ...
Capturing the image
The image is captured by two cameras
integrated in the exterior mirrors and by the
backup camera.
The range is at least 7 ft/2 m to the side and rear.
In this way, obstacles up to the height of ...
Date
The settings are stored for the remote control
currently in use.
Setting the date
1. "Settings"
2. "Time/Date"
3. "Date:"
4. Turn the controller until the desired ...