Tail lamps, bulb replacement
At a glance

1. Turn signal
2. Reversing lamp
3. Inside brake lamp
4. Tail lamp
5. Outside brake lamp
6. Rear reflector
Turn signal, outer brake, tail, and license plate lamps
Follow the general instructions on lamps and bulbs
These lights are made using LED technology.
Contact your service center in the event of a malfunction
Lamps in the trunk lid
Access to the lamps
1. Remove the three screws using the screw driver from the onboard vehicle tool kit.

2. Fold away the cover.

Inside brake lamp
Follow the general instructions on lamps and bulbs
21-watt bulb, H21W

The illustration shows the position of the bulb in the installed bulb holder

Squeeze the clips together and remove the bulb holder.
Press the bulb into the bulb holder, turn counterclockwise and remove.
Reversing lamp
Follow the general instructions on lamps and bulbs
16-watt bulb, W16W

The illustration shows the position of the bulb in the installed bulb holder.

Squeeze the clips together and remove the bulb holder.
Pull out the bulb and replace it.
See also:
Display on the Control Display
Switching on the backup camera via
iDrive
With Top View switched on:
"Rear view camera"
The backup camera image is displayed. The setting
is stored for the remote control currently i ...
Adjusting the volume
1. "CD/Multimedia", "Radio" or "Settings"
2. "Tone"
3. "Volume settings"
4. Select the desired volume setting.
Select the desired volume setting ...
Engine oil
Vehicle equipment
All standard, country-specific and optional
equipment that is offered in the model series is
described in this chapter. Therefore, equipment
is also described that is not avai ...
