Initialization
The initialization process adopts the set inflation tire pressures as reference values for the detection of a flat tire. Initialization is started by confirming the inflation pressures.
Do not initialize the system when driving with snow chains.
1. "Vehicle Info"
2. "Vehicle status"
3. 
"Reset"
4. Start the engine - do not drive away.
5. Start the initialization with "Reset".
6. Drive away.
The initialization is completed while driving, which can be interrupted at any time.
The initialization automatically continues when driving resumes.
See also:
Radar sensor
Position
Radar sensor
Dirty or covered sensor
A dirty or covered sensor may hinder the detection
of vehicles.
If necessary, clean the radar sensor. Remove
layers of snow and ice carefull ...
Adjusting the height: manual head
restraints
The height of the outer head restraints can be
adjusted.
To raise: pull.
To lower: press the button, arrow 1, and
push the head restraint down.
...
Hazard warning flashers
Hazard warning flashers
The button for the hazard warning system is located
on the center console. ...