Initialization after a power failure

After a power failure, it is only possible to raise the roof, if necessary.

Have the system initialized by your service center.

    See also:

    Switching the warning function on/off
    Switching the warning function on/off Press the button ▷ On: the LED lights up. ▷ Off: the LED goes out. The state is stored for the remote control currently in use. ...

    Planning a trip with intermediatedestinations
    New trip 1. "Navigation" 2. "Map" 3. Move the controller to the left if necessary. 4. "Guidance" 5. "Enter new destination" 6. Select the type of destina ...

    Radio Data System RDS
    In the FM waveband, additional information is transmitted via RDS. If the reception conditions are good, the station names are shown on the Control Display. Where reception is poor or in the event ...