Brightness

Setting the brightness

To set the brightness of the Control Display:

1. "Settings"

2. "Control display"

3. "Brightness"

4. Turn the controller until the desired brightness

4. Turn the controller until the desired brightness is set.

5. Press the controller.

The setting is stored for the remote control currently in use.

Depending on the light conditions, the brightness control may not be clearly visible.

    See also:

    TeleService Battery Guard
    TeleService Battery Guard continually checks the battery charge level of the vehicle. If the battery charge level falls below a certain value, a notification is automatically sent to your service ...

    Configuring the warning time
    After the warning function is switched on, the warning time can be set via the iDrive. For a late warning time, prewarning is deactivated. These settings have no effect on the time of the warni ...

    Putting into operation after a power failure
    Putting the parking brake into operation The parking brake should only be put into operation again if it was manually released due to an interruption in the supply of electrical power. Otherw ...