Mounting LATCH child restraint fixing systems on power rear seats
1. Before mounting, adjust the seats to their basic position.
2. For better accessibility, tilt the backrest back slightly.
3. Mount the child restraint fixing system; refer to the operating instructions of the system.
4. Ensure that both LATCH anchors are properly connected.
5. After mounting, move the backrest back up slightly so that the child restraint fixing system rests lightly against the backrest.
See also:
Increasing or decreasing vehicle speed
You can specify your desired speed in the range
from approx. 4 mph/6 km/h to approx. 15 mph/
25 km/h using the rocker switch of the cruise
control on the steering wheel. You can change
the veh ...
Deactivating the system
▷ Press the lever upward or downward twice,
arrow 3.
▷ Switch off the ignition.
The stored speed is cleared. ...
General information
Refuel promptly
Refuel no later than at a range of 30 miles/50 km, or operation of the engine is
not ensured and damage may occur.◄ ...