The concept
This system can replace up to three different hand-held transmitters for various types of remote- controlled equipment, such as garage doors or lighting systems.
The hand-held transmitter signal can be programmed on one of the three memory buttons.
The corresponding device can then be operated using the programmed memory button.
The LED indicates that a signal is being transmitted.
When selling the vehicle, delete the stored programs for security reasons.
During programming
During programming and before activating
a device using the integrated universal remote
control, ensure that there are no people,
animals, or objects in the range of movement of
the remote-controlled device; otherwise, there
is a risk of injury or damage.
Also follow the safety instructions of the handheld transmitter.◀
See also:
Programming
Programming
1. Memory buttons
2. LED
Fixed-code hand-held transmitters
1. Switch on the ignition, refer to page 61.
2. Initial setup:
Press both outer memory buttons 1 for approx.
20 seconds ...
General information
Refuel promptly
Refuel no later than at a range of 30 miles/50 km, or operation of the engine is
not ensured and damage may occur.◄ ...
Environmental conditions
Say the commands, numbers, and letters
smoothly and with normal volume, emphasis,
and speed.
Always say commands in the language of
the voice activation system.
When selecting a radio ...