Fold-out position of the wipers

Required when changing the wiper blades or under frosty conditions, for example.

1. Switch off the ignition.
2. Under frosty conditions, ensure that the wiper blades are not frozen onto the windshield.
3. Press the wiper lever up beyond the point of resistance and hold it for approx. 3 seconds, until the wiper remains in a nearly vertical position.

After the wipers are folded back down, the wiper system must be reactivated.

Before switching the ignition on, fold the Fold the wipers back down
Before switching the ignition on, fold the wipers back down to the windshield; otherwise, the wipers may become damaged when they are switched on.◀

1. Switch on the ignition.
2. Press the wiper levers down. The wipers move to their resting position and are ready for operation.

    See also:

    Clean the windshield, headlamps
    Pull the lever. The system sprays washer fluid on the windshield and activates the wipers briefly. In addition, the headlamps are cleaned at regular intervals when the vehicle lights are switc ...

    Measurement
    Measurements are made by ultrasound sensors in the bumpers. The range is approx. 6 ft/2 m. An acoustic warning is first given: ▷ By the front sensors and two rear corner sensors at approx ...

    Closing
    Danger of pinching Monitor the closing process and make sure that the closing path of the window is clear; otherwise, injuries may result.◀ ▷ Pull the switch to the resistance po ...