Initializing after a power failure

After a power failure during the opening or closing process, the roof can only be operated to a limited extent.

Initializing the system

The system can be initialized when the vehicle is stationary and the engine is running.

During the initialization, the roof closes without pinch protection.

Monitor the closing process and make Danger of pinching
Monitor the closing process and make sure that the closing path of the glass sunroof is clear; otherwise, injuries may result.◀

until the initialization is complete: Press the switch up and hold it until the initialization is complete:

▷ Initialization begins within 15 seconds and is completed when the sunroof and sliding visor are completely closed.
▷ The roof closes without pinch protection.

    See also:

    Vehicle equipment
    All standard, country-specific and optional equipment that is offered in the model series is described in this chapter. Therefore, equipment is also described that is not available in a vehicle, ...

    Deleting contacts
    Only contacts that are stored in the vehicle are deleted. The contacts on the mobile phone cannot be deleted. 1. "Office" 2. "Contacts" 3. Highlight the contact. 4. Open &q ...

    Measurement
    Measurements are made by ultrasound sensors in the bumpers. The range is approx. 6 ft/2 m. An acoustic warning is first given: By the front* sensors and the two rear corner sensors at appro ...