Following part replacement
The same breaking in procedures should be observed if any of the components mentioned above have to be renewed in the course of the vehicle's operating life.
See also:
Speed limit
Entry of a speed limit which, when reached,
should cause a Check Control message to be
issued.
Renewed warning if the vehicle speed drops below
the set speed limit once by at least 3 mph/
5 k ...
Switch off any functions that are not
currently needed
Functions such as seat heating and the rear window
defroster require a lot of energy and consume
additional fuel, especially in city and stopand-
go traffic.
Therefore, switch off these functio ...
Sockets
The lighter socket can be used as a socket for
electrical equipment while the engine is running
or when the ignition is switched on. The total
load of all sockets must not exceed 140 watt at
1 ...
