Preparation

1. Check whether the battery of the other vehicle has a voltage of 12 volts and approximately the same capacitance in Ah. This information can be found on the battery.
2. Switch off the engine of the assisting vehicle.
3. Switch off any electronic systems/power consumers in both vehicles.

There must not be any contact between Bodywork contact between vehicles
There must not be any contact between the bodies of the two vehicles, otherwise there is a danger of shorting.◀

    See also:

    Headlamp courtesy delay feature
    The low beams stay lit for a short while if the headlamp flasher is switched on after the ignition is switched off. Setting the duration 1. "Settings" 2. "Lighting" 3. &quo ...

    All around the center console
    All around the center console 1. Headliner 2. Control Display 3. Glove compartment 4. Air vent 5. Hazard warning system Central locking system 6. Radio CD/Multimedia 7. Automatic climate ...

    Traffic bulletins on the map
    "Traffic conditions/gray map" Active: indication on the control display is switched to shades of gray. This enables a better view of the traffic bulletins. Day/night mode is not taken ...