Signal tones

When approaching an object, an intermittent tone is sounded that indicates the position of the object. For example, if an object is detected to the left rear of the vehicle, a signal tone sounds from the left rear speaker.

The shorter the distance to the object becomes, the shorter the intervals.

If the distance to a detected object is less than approx. 12 in/30 cm, a continuous tone is sounded.

If objects are located both in front of and behind the vehicle, an alternating continuous signal is sounded.

The intermittent tone is interrupted after approx.

3 seconds:

▷ If the vehicle stops in front of an object that is detected by only one of the corner sensors.

▷ If moving parallel to a wall.
The signal tone is switched off:
▷ When the vehicle moves away from an object by more than approx. 4 in/10 cm.
▷ When transmission position P is engaged.

Volume

You can set the volume of the PDC signal tone

The setting is stored for the remote control currently in use

    See also:

    Requirements
    Via the Control Display, set a language that is also supported by the voice activation system so that the spoken commands can be identified. Set the language. ...

    Checking the engine oil level
    Your car is equipped with an electronic engine oil level check. Requirements ▷ The engine must be running and warm after the vehicle has been driven for at least 6.2 miles/10 km. ▷ ...

    At a glance
    1. Function bar 2. Route section with traffic obstruction 3. Traffic sign for traffic obstruction 4. Planned route 5. Current location 6. Upper status field 7. Lower status field Lines in the ...