Putting into operation after a power failure
Putting the parking brake into operation
The parking brake should only be put into
operation again if it was manually released due
to an interruption in the supply of electrical
power. Otherwise the operation of the parking
brake is not ensured and there is a danger of the
vehicle rolling despite the parking brake being
set.◀
Procedure
1. Switch on the ignition.
2. Press the button with the brake depressed.
The indicator lamp in the
instrument
cluster goes out as soon as the parking
brake is ready for operation.
Indicator lamp in Canadian
models.
Any noises which occur are normal. Startup may take several seconds.
See also:
Measurement
Measurements are made by ultrasound sensors
in the bumpers.
The range is approx. 6 ft/2 m.
An acoustic warning is first given:
By the front* sensors and the two rear corner
sensors at appro ...
Changing batteries
Changing batteries
1. Press the detent and remove the cover.
2. Change the batteries. The type and installation
position are marked on the bottom of
the battery compartment.
3. Close the cove ...
Transmitting the settings
Your personal settings can be taken with you to
another vehicle equipped with the Personal Profile
function. For more information, contact your
service center.
Transmission takes place via:
&# ...