Resetting the system

Reset the system after each correction of the tire inflation pressure and after every tire or wheel change.

1. "Vehicle Info"
2. "Vehicle status"
3. 4. Start the engine - do not drive away. "Reset"
4. Start the engine - do not drive away.
5. Reset the tire pressure using "Reset".
6. Drive away.

The tires are shown in gray and "Resetting TPM..." is displayed.

After driving for a few minutes, the set tire inflation pressures are applied as set values. The resetting process is completed automatically during driving. The tires are shown in green and "TPM active" is shown on the Control Display.

The trip can be interrupted at any time. If you drive away again, the process resumes automatically.

If a flat tire is detected during a reset, all tires are displayed in yellow.

    See also:

    Brightness
    Setting the brightness To set the brightness of the Control Display: 1. "Settings" 2. "Control display" 3. "Brightness" 4. Turn the controller until the desired ...

    Requirements
    The installed BMW Assist system is logged in to a wireless communications network. This network must be capable of transmitting the services. To transmit position data, the vehicle must ...

    DSC OFF
    Driving stability is limited during acceleration and when driving in bends. Stabilizing interventions by the Integral Active Steering* system are only performed by the rear axle steering. To i ...