After a power failure

after a power failure Only put the parking brake into operation after a power failure

The parking brake should only be put into operation again if it was manually released due to an interruption in the supply of electrical power. Otherwise, it cannot be ensured that the parking brake will function properly.

Putting the parking brake into operation

1. Switch on the ignition.

2. brake is depressed Press the switch while the brake is depressed or transmission position P is engaged.

It may take several seconds for the brake to be put into operation. Any sounds associated with this are normal.

instrument The indicator lamp in the instrument cluster goes out as soon as the parking brake is ready for operation.

Canadian Lower lamp: indicator lamp in Canadian models.

    See also:

    Voice operation
    Vehicles equipped with the voice activation system: operation. Vehicles not equipped with the voice activation system: depending on the equipment, the mobile phone can be voice operated as descr ...

    Vehicle equipment
    All standard, country-specific and optional equipment that is offered in the model series is described in this chapter. Therefore, equipment is also described that is not available in a vehicle, ...

    Comfort position
    In the comfort position, the roof is not fully open. This reduces wind noise in the passenger compartment. Each time the glass sunroof is opened or closed all the way, it stops in the comfort posi ...