Signal tones
When approaching an object, an intermittent tone is sounded that indicates the position of the object. For example, if an object is detected to the left rear of the vehicle, a signal tone sounds from the left rear speaker.
The shorter the distance to the object becomes, the shorter the intervals.
If the distance to a detected object is less than approx. 12 in/30 cm, a continuous tone is sounded.
If objects are located both in front of and behind the vehicle, an alternating continuous signal is sounded.
The intermittent tone is interrupted after approx.
3 seconds:
▷ If the vehicle stops in front of an object that
is detected by only one of the corner sensors.
▷ If moving parallel to a wall.
The signal tone is switched off:
▷ When the vehicle moves away from an object
by more than approx. 4 in/10 cm.
▷ When transmission position P is engaged.
Volume
You can set the volume of the PDC signal tone, The setting is stored for the remote control currently in use.
See also:
Tachometer
Always avoid engine speeds in the red warning
field. In this range, the fuel supply is interrupted
to protect the engine. ...
Comfort position
In the comfort position, the roof is not fully open.
This reduces wind noise in the passenger compartment.
Each time the glass sunroof is opened or closed
all the way, it stops in the comfort posi ...
Navigation
This chapter contains various examples of how
the navigation system can guide you reliably to
your destination. ...
