Releasing

With the ignition switched on:

switch Manual transmission: Press the switch while the brake or clutch is pressed.

Automatic transmission: Press the switch while the brake is pressed or transmission position P is engaged.

The LED and indicator lamp go out.

The parking brake is released.

Automatic Release in cars with automatic transmission

For automatic release, operate the accelerator pedal.

The LED and indicator lamp go out.

Subject to the following requirements, the parking brake is automatically released by operation of the accelerator pedal:

▷ Engine on.
▷ Drive position engaged.
▷ Driver buckled in and doors closed.

pedal Inadvertent operation of the accelerator pedal
Make sure that the accelerator pedal is not operated unintentionally; otherwise, the vehicle is set in motion and there is a risk of an accident.◀

    See also:

    Redialing
    General information The list of dialed numbers in the mobile phone is transmitted to the vehicle depending on the mobile phone. Possibly only those numbers are displayed that were dialed from t ...

    Roadside Assistance
    At a glance BMW Roadside Assistance can be contacted if assistance is needed in the event of a breakdown. Roadside Assistance can also be contacted via a Check Control message ...

    Service data in the remote control
    Information on the required maintenance is continuously stored in the remote control. Your service center will read out this data and suggest the right array of service procedures for your vehic ...