See also:

Programming
Programming 1. Memory buttons 2. LED Fixed-code hand-held transmitters 1. Switch on the ignition, refer to page 61. 2. Initial setup: Press both outer memory buttons 1 for approx. 20 seconds ...

Settings for the map view
The settings are stored for the remote control currently in use. 1. "Navigation" 2. "Map" 3. Open "Options". 4. "Settings" Set the map view. ► &q ...

Starting destination guidance
1. "Navigation" 2. Make a destination entry. 3. "Accept destination" 4. "Start guidance" The route is shown on the Control Display. The distance to the destination/i ...