Activating the High-beam Assistant
1. Turn the light switch to .
2. With the low beams switched on, briefly push the turn indicator lever in the direction of the high beam.

Activating the High-beam Assistant
The indicator lamp
in the instrument
cluster lights up. The high beams are
switched on and off automatically.
The system responds to light from oncoming traffic and traffic driving ahead of you, and to adequate illumination, e.g., in towns and cities.
See also:
Brake system
Brakes require an initial break-in period of approx.
300 miles/500 km to achieve optimized
contact and wear patterns between brake pads
and rotors. Drive cautiously during this break-in
period. ...
Fuel cap
The indicator lamp
lights up.
If the fuel cap is not properly tightened,
the OBD system may conclude that
fuel vapor is escaping. If the cap is then tightened,
the display should go out in a ...
Navigation data
General informationNavigation data and authorization codes are available from your BMW center. Navigation
data are stored in the vehicle and can be updated.
> Depending on the data volume, a dat ...
