Ignition lock

Insert the remote control into the ignition lock

Insert the remote control all the way into the ignition lock.

Insert the remote control all the way into the ignition lock.

> Radio readiness is switched on.

Individual electrical consumers can operate.

Comfort Access

If the car is equipped with Comfort Access, only insert the remote control into the ignition lock under special circumstances.

Removing the remote control from the ignition lock

of the ignition lock as this may cause damage. Do not forcibly pull the remote control out of the ignition lock as this may cause damage.

Before removing the remote control, push it all the way in to release the locking mechanism.

> The ignition is switched off if it was on.

Automatic transmission

You cannot take out the remote control unless the selector lever is in the P position: interlock.

    See also:

    Preparation
    1. Check whether the battery of the other vehicle has a voltage of 12 volts and approximately the same capacitance in Ah. This information can be found on the battery. 2. Switch off the engine ...

    Communication
    All of the options available to you for mobile communication with family, friends, business partners, and service providers are described in this chapter. ...

    Tire tread
    Summer tires Do not drive with a tire tread depth of less than 0.12 in/3 mm. There is an increased danger of hydroplaning if the tread depth is less than 0.12 in/3 mm. Winter tires Do not driv ...