Functional requirement
▷ To lock the vehicle, the remote control must
be located outside of the vehicle..
▷ The next unlocking and locking cycle is not
possible until after approx. 2 seconds..
▷ The engine can only be started if the remote
control is inside the vehicle.
See also:
Programming
Programming
1. Memory buttons
2. LED
Fixed-code hand-held transmitters
1. Switch on the ignition, refer to page 61.
2. Initial setup:
Press both outer memory buttons 1 for approx.
20 seconds ...
Snap-in adapter
The snap-in adapter is used to:
▷ Hold the mobile phone.
▷ Recharge the battery.
▷ Connect the mobile phone to an outside antenna
of the vehicle.
This provides for better netwo ...
LATCH child restraint fixing system
LATCH: Lower Anchors and Tethers for CHildren.
Coupe: rear seats
The anchor points for the lower LATCH anchors are located behind the labeled
protective caps.
Convertible: rear seats
To inst ...