Settings for the map view

The settings are stored for the remote control currently in use.

1. "Navigation"
2. "Map"
3. "Options" Open.
4. "Settings"
Set the map view.

▷ "Day/night mode"
Select and create the necessary settings depending on the light conditions.
"Traffic conditions/gray map" active: the setting is disregarded.
▷ "Satellite images"
Depending on availability and resolution, satellite images are displayed in a scale of approx. 1 mile to 600 miles/2 km to 1,000 km.
▷ "Perspective view in 3D"
Prominent areas that are contained in the navigation data are displayed on the map in 3D.
▷ "Traffic conditions/gray map"
The map is optimized for displaying traffic bulletins. Symbols for the special destinations are no longer displayed.

    See also:

    Buttons on the remote control
    Buttons on the remote control 1 Unlocking 2 Locking 3 Opening the trunk lid 4 Panic mode in alarm system ...

    Switch off any functions that are not currently needed
    Functions such as seat heating and the rear window defroster require a lot of energy and consume additional fuel, especially in city and stopand- go traffic. Therefore, switch off these functio ...

    General information
    The navigation system can determine the precise position of the vehicle, with the aid of satellites and vehicle sensors, and can reliably guide you to every entered destination. Entries in st ...