Functional requirements
The system must have been initialized when the tire inflation pressure was correct; otherwise, reliable signaling of a flat tire is not ensured. Initialize the system after each correction of the tire inflation pressure and after every tire or wheel change.
See also:
Washer fluid reservoir
Adding washer fluid
Only add washer fluid when the engine is
cool, and then close the cover completely to
avoid contact between the washer fluid and hot
engine parts.
Otherwise, there is ...
Image on the Control Display
Switching on the rear view camera
using iDrive
With Top View activated:
"Rear
view camera"
The image of the rear view camera is displayed.
The setting is stored for the ...
Tire inflation pressures up to 100 mph/160 km/h
For speeds of up to 100 mph/160 km/h and for
optimum driving comfort, note the pressure values
in the tire inflation pressure table, refer to
page 238, and adjust as necessary.
These pressure va ...