Connecting the cables

1. Open the cover of the BMW starting aid terminal.

2. Attach one terminal clamp of the positive jumper cable to the positive terminal of the battery, or to the corresponding starting aid terminal of the assisting vehicle.

3. Attach the other end of the cable to the positive terminal of the battery, or to the corresponding starting aid terminal of the vehicle to be started.

4. Attach one terminal clamp of the negative jumper cable to the negative terminal of the battery, or to the corresponding engine or body ground of assisting vehicle.

5. Attach the other end of the cable to the negative terminal of the battery, or to the corresponding engine or body ground of the vehicle to be started.

    See also:

    After a power failure
    Only put the parking brake into operation after a power failure The parking brake should only be put into operation again if it was manually released due to an interruption in the supply of el ...

    Displaying stored Check Controlmessages
    1. "Vehicle Info" 2. "Vehicle status" 3. "Check Control" 4. Select the text message. ...

    Adjusting
    Danger of burns when screen is folded out Do not reach behind the screen; otherwise, there is the danger of getting burned. The back of the screen can become very hot. To fold out: pull ...