Resetting the system

Reset the system after each correction of the tire inflation pressure and after every tire or wheel change.

1. "Vehicle Info"

2. "Vehicle status"

3. 4. Start the engine - do not drive away. "Reset"

4. Start the engine - do not drive away.

5. Reset the tire pressure using "Reset".

6. Drive away.

The tires are shown in gray and "Resetting TPM..." is displayed.

After driving for a few minutes, the set tire inflation pressures are applied as set values. The resetting process is completed automatically as you drive. The tires are shown in green and "TPM active" is shown on the Control Display.

The trip can be interrupted at any time. If you drive away again, the process resumes automatically.

Do not reset the system when driving with a compact wheel.

If a flat tire is detected while the system is resetting, all tires on the Control Display are displayed in yellow. The message "Low tire!" is shown.

    See also:

    Low tire pressure message
    The small warning lamp lights up yellow and the large warning lamp lights up red. A message appears on the Control Display. In addition, a signal sounds. ▷ There is a flat tire or a ...

    Manual transmission
    Starting the engine 1. Depress the brake pedal. 2. Press on the clutch and shift to neutral. 3. Press the Start/Stop button. The ignition is activated automatically for a certain time and is sto ...

    Stowing cargo
    Heavy cargo: stow as far forward and as low as possible, ideally directly behind the cargo area separating wall. Very heavy cargo: when the rear seat is not occupied, secure each of th ...