Emergency detection of remote control

It is possible to switch on the ignition or start the engine in situations such as the following:

▷ Interference of radio transmission to remote control by external sources.
▷ Discharged battery in the remote control.

A Check Control message is displayed if an attempt is made to switch on the ignition or start the engine.

Starting the engine in case of emergency detection of remote control

Starting the engine in case of
Starting the engine in case of emergency detection of remote control

Automatic transmission: if a corresponding Check Control message appears, hold the remote control, as shown, against the marked area on the steering column and press the Start/Stop button within 10 seconds while pressing the brake.

Manual transmission: if a corresponding Check Control message appears, hold the remote control, as shown, against the marked area on the steering column and press the Start/Stop button within 10 seconds while pressing the clutch.

    See also:

    In the cargo area
    Open the cover on the right side trim. Information on the fuse types and locations is found on a separate sheet. ...

    DSC OFF
    When DSC OFF, is active, driving stability is limited during acceleration and when driving in bends. ...

    Pairing and connecting a device
    Pairing a device To avoid becoming distracted and posing an unnecessary hazard both to your own vehicle's occupants and to other road users, only pair the device while the vehicle is stationar ...