Calibrating the digital compass

The digital compass must be calibrated in the event of the following:

▷ The wrong point of the compass is displayed.

▷ The point of the compass displayed does not change despite changing the direction of travel.

▷ Not all points of the compass are displayed.

Procedure

1. Make sure that there are no large metallic objects or overhead power lines near the vehicle and that there is sufficient room to drive around in a circle.

2. Set the currently applicable compass zone.

3. Press and hold the control button for approx.

6 to 7 seconds so that "C" appears on the display. Next, drive in a complete circle at least once at a speed of no more than 4 mph/ 7 km/h. If calibration is successful, the "C" is replaced by the points of the compass.

    See also:

    Vehicle equipment
    All standard, country-specific and optional equipment that is offered in the model series is described in this chapter. Therefore, equipment is also described that is not available in a vehicle, e ...

    Display
    1 Lane departure warning 2 Active Cruise Control 3 Desired speed 4 Navigation system 5 Speed The collision warning, Night Vision pedestrian warning, or Check Control messages are displayed ...

    Parking lamps
    Switch position     : the vehicle lamps light up on all sides, e.g., for parking. Do not use the parking lamps for extended periods; otherwise, the battery may become discharged ...