Image on the Control Display
Switching on the rear view camera using iDrive
With PDC activated:
"Rear view camera"
The image of the rear view camera is displayed.
The setting is stored for the remote control currently in use.
Brightness
With the rear view camera switched on:
1. 
Select the symbol.
2. Turn the controller until the desired setting is reached and press the controller.
Contrast
With the rear view camera switched on:
1. 
Select the
symbol.
2. Turn the controller until the desired setting is reached and press the controller.
See also:
Driving through water
Drive though calm water only if it is not deeper
than 9.8 inches/25 cm and at this height, no
faster than walking speed, up to 6 mph/10 km/h.
Adhere to water depth and speed limitations
Do not ...
Emergency detection of remote control
It is possible to switch on the ignition or start the
engine in situations such as the following:
▷ Interference of radio transmission to remote
control by external sources.
▷ Discha ...
Avoid high engine speeds
Use 1st gear to get the vehicle in motion. Beginning
with 2nd gear, accelerate rapidly. When
accelerating, shift up before reaching high engine
speeds.
When you reach the desired speed, shift i ...