Switching off the engine
Procedure
1. Engage transmission position P with the vehicle stopped.
2. Press the Start/Stop button.
3. Set the parking brake.
4. Remove the remote control from the ignition lock
Before driving into a car wash
The vehicle is able to roll when the following steps are adhered to:
1. With Comfort Access: insert the remote control in the ignition lock.
2. Depress the brake pedal.
3. Engage transmission position N.
4. Release the parking brake or deactivate Automatic Hold.
5. Switch the engine off.
Transmission position P will be engaged:
▷ Automatically after approx. 30 minutes.
▷ If you remove the remote control from the
ignition lock.
See also:
Roadside Assistance
At a glance
BMW Roadside Assistance* can be contacted if
assistance is needed in the event of a breakdown.
Roadside Assistance* can also be contacted via
a Check Control message.
Starting Roads ...
Increasing or reducing speed
The speed can be changed in the range from
approx. 4 mph/6 km/h to approx. 15 mph/25 km/
h by pressing the accelerator or brake pedal
lightly.
A target speed within the same range can be
spec ...
Electromechanical steering increases agility and comfort
The driving enjoyment, agility and comfort are also down to an accurate
steering system which always gives the driver precise feedback. The typical BMW
rear-wheel-drive setup, which eliminates tor ...