Tail lamps, bulb replacement
At a glance
1 Turn signal
2 Backup lamp
3 Inside brake lamp*
4 Tail lamp
5 Outside brake lamp
6 Rear reflector*
Turn signal, brake, tail, and license plate lamps
Follow the general instructions on lamps and bulbs.
These lights are made using LED technology.
Contact your service center in the event of a malfunction.
Lamps in the trunk lid
Follow the general instructions on lamps and bulbs.
Access to the lamps
1. Remove the three screws using the screw driver from the tool kit.
2. Fold away the cover.
3. Replace the defective bulb.
Inside brake lamp
21-watt bulb, H21W.
Pull out the bulb and replace it.
Backup lamp
16-watt bulb, W16W.
Pull out the bulb and replace it.
See also:
Manual destination entry
General information
The system supports you in entering street
names and house numbers by automatically
completing the entry and providing entry comparisons,
refer to page 21.
Stored town/city ...
Headlamp courtesy delay feature
The low beams stay lit for a short while after the
ignition is switched off, if the lamps are switched
off and the headlamp flasher is switched on.
Setting the duration
1. "Settings"
2. ...
Setting
Pull the switch.
The LED lights up.
The indicator lamp lights up in
red. The
parking brake is set.
Lower lamp: indicator lamp in
Canadian
models
Set the parking brake and further secur ...