Settings for the map view

The settings are stored for the remote control currently in use.

1. "Navigation"

2. "Map"

3. Open "Options".

4. "Settings"

Set the map view.

  • "Day/night mode"
    Select and create the necessary settings depending on the light conditions. "Traffic conditions/gray map" active: the setting is disregarded.
  • "Satellite images"
    Depending on availability and resolution, satellite images* are displayed in a scale of approx. 1 mile to 600 miles/2 km to 1,000 km.
  • "Perspective view in 3D"
    Prominent areas that are contained in the navigation data are displayed on the map in 3D.
  • "Traffic conditions/gray map"
    The map is optimized for displaying traffic bulletins. Symbols for the special destinations are no longer displayed.
    See also:

    Switching on/off
    Press the button. ▷ On: the LED lights up. ▷ Off: the LED goes out. The system can issue warnings at speeds above approx. 30 mph/50 km/h. The state is stored for the remote contro ...

    Contacts
    General informationContacts can be created and edited. The contacts from the mobile phone are displayed as well, if this function is supported by the mobile phone. The addresses can be used as des ...

    VALVETRONIC, Double-Vanos and direct injection
    The combination of a high power output and a simultaneous reduction in emissions is achieved by VALVETRONIC variable valve timing and Double-Vanos variable camshaft timing. The latest generation o ...