Drive-off assistant
This system supports driving away on gradients. The parking brake is not required.
1. Hold the vehicle in place with the foot brake.
2. Release the foot brake and drive away without delay.
After the foot brake is released, the vehicle is held in place for approx. 2 seconds.
Depending on the vehicle load, the vehicle may roll back slightly.
Driving off without delay
After releasing the foot brake, start driving without delay, since the drive-off assistant will not hold the vehicle in place for more than approx. 2 seconds and the vehicle will begin rolling back.
See also:
Functional requirements
The system must have been reset while the inflation
pressure was correct; otherwise, reliable
signaling of a flat tire is not ensured.
Always use wheels with TPM electronics to ensure
that the ...
Roadside parking lamps
The vehicle can be illuminated on one side.
Switching on
With the ignition switched off, press the lever
either up or down past the resistance point for
approx. 2 seconds.
Switching off
Brie ...
Issuing a warning
If the vehicle begins leaving the lane and a lane
marking has been detected, the steering wheel
begins vibrating.
If the turn signal is set before the lane is
changed, a warning is not issued.
...
