Releasing

With the ignition switched on:

the switch Automatic transmission: Press the switch while the brake is pressed or transmission position P is engaged.

The LED and indicator lamp go out.

The parking brake is released.

Automatic Release in cars with automatic transmission

For automatic release, operate the accelerator pedal.

The LED and indicator lamp go out.

Subject to the following requirements, the parking brake is automatically released by operation of the accelerator pedal:

► Engine on.
► Drive position engaged.
► Driver buckled in and doors closed.

pedal Inadvertent operation of the accelerator pedal
Make sure that the accelerator pedal is not operated unintentionally; otherwise, the vehicle is set in motion and there is a risk of an accident.◄

    See also:

    Roadside Assistance
    At a glance BMW Roadside Assistance can be contacted if assistance is needed in the event of a breakdown. Roadside Assistance can also be contacted via a Check Control message. Start Roadside A ...

    Switching the high beams on and off manually
    Switching the high beams on and off manually ▷ High beams on, arrow 1. ▷ High beams off/headlamp flasher, arrow 2. To reactivate the High-beam Assistant, press the button on the t ...

    After a power failure
    Only put the parking brake into operation after a power failure The parking brake should only be put into operation again if it was manually released due to an interruption in the supply of el ...