Checking the coolant level

1. Do not open the hood until the engine has cooled down.
2. Turn the expansion tank cap counterclockwise slightly to allow any accumulated pressure to escape; then continue turning to open.
3. The coolant level is correct if it is between the maximum and minimum marks in the filler neck, refer also to the diagram next to the filler neck.
4. If the coolant is low, slowly add coolant up to the specified level; do not overfill.
5. Turn the cap until there is an audible click.
6. Have the cause of the coolant loss eliminated as soon as possible.

Disposal

appropriate environmental Comply with the appropriate environmental protection regulations when disposing of coolant additives.

    See also:

    System limits
    The cameras capture a maximum range of 330 ft/100 m. Display The images from both cameras are shown simultaneously on the Control Display. Check the traffic situation as well Check the tra ...

    Configuring the prewarning
    After the warning function is switched on, the following can be set via the iDrive: ▷ The prewarning can be switched on/off. ▷ The time of the prewarning can be set. These settings ha ...

    Sound output
    Switching on/off When the ignition is switched off: press ON/OFF button on the radio. Muting When the ignition is switched on or the engine is running: press the ON/OFF button on the radio. ...