Snap-in adapter
The snap-in adapter is used to:
▷ Hold the mobile phone.
▷ Recharge the battery.
▷ Connect the mobile phone to an outside antenna
of the vehicle.
This provides for better network reception and consistent sound quality.
See also:
Exterior
The new 6 Series measures some 3 inches longer and 1.5 inches wider than its
predecessor; it's a few tenths of an inch shorter at the roof level. As before,
the car maintains a short front overhan ...
Functional requirements
The system must have been initialized when the
tire inflation pressure was correct; otherwise,
reliable signaling of a flat tire is not ensured. Initialize
the system after each correction of th ...
Avoiding unintentional alarms
The tilt alarm sensor and interior motion sensor
can be switched off together, such as in the following
situations:
▷ In duplex garages.
▷ During transport on car-carrying trains, at ...
