Residual heat

The heat stored in the engine is used to heat the interior.

Functional requirement

▷ Up to 15 minutes after the engine has been switched off.
▷ Warm engine.
▷ The battery is sufficiently charged.
▷ External temperature below 77 ℉/25 ℃.

Switching on

1. Switch off the ignition.

2. Press the right-hand button.

the automatic REST appears on the display of the automatic climate control when the residual heat utilization is switched on.

From radio readiness the interior temperature, the air volume and the air distribution can be set.

Switching off

You can select the lowest blower speed by pressing and holding the left side. Pressing again switches off the residual heat utilization.

REST disappears from the display of the automatic climate control.

    See also:

    Setting compass zones
    Set the compass zone corresponding to the vehicle's geographic location so that the compass Setting compass zones Press the adjustment button for 3‑4 seconds. The number of the compass zo ...

    Car washes
    Notes Steam jets or high-pressure washers When using steam jets or high-pressure washers, hold them a sufficient distance away and use a maximum temperature of 140 ℉/ 60 ℃. Holdi ...

    Safety belt reminder for the driver's and front passenger seat
    The indicator lamp flashes or lights up and a signal sounds. Make sure that the safety belts are positioned correctly. The safety belt reminder is active at speeds above approx. 5 mph/8 km/h ...