Functional requirements
The system must have been initialized when the tire inflation pressure was correct; otherwise, reliable signaling of a flat tire is not ensured. Initialize the system after each correction of the tire inflation pressure and after every tire or wheel change.
See also:
Storing
1. Switch on the ignition.
2. Set the desired position.
3. Press the button. The LED in
the
button lights up.
4. Press the desired button 1 or
2. The LED
goes out.
If the M button is pre ...
Switching off automatically
The system switches off and the LED goes out:
▷ After approx. 160 ft/50 m when driving forward.
▷ Above approx. 22 mph/36 km/h when driving
forward.
Switch on the system again if nece ...
Automatic trunk lid operation
Opening
The trunk lid opens fully.
Press the button on the exterior of the trunk
lid.
Press the button on the
remote
control or in the driver's footwell.
Pressing the button agai ...