Avoiding unintentional alarms

The tilt alarm sensor and interior motion sensor can be switched off together, such as in the following situations:

▷ In automatic car washes.

▷ In duplex garages.

▷ During transport on car-carrying trains, at sea or on a trailer.

▷ When animals are to remain in the vehicle.

Switching off the tilt alarm sensor and interior motion sensor

again Press the remote control button again within 10 seconds as soon as the vehicle is locked.

The indicator lamp lights up for approx. 2 seconds and then continues to flash.

The tilt alarm sensor and interior motion sensor are switched off until the vehicle is locked again.

    See also:

    Reading lamps
    Press the button. Reading lamps are located at the front and rear next to the interior lamps. ...

    Resuming the original route
    If the route section should no longer be bypassed: 1. "Navigation" 2. "Route information" 3. "New route for:" 4. "Remove blocking" ...

    Radar sensor
    Position Radar sensor Dirty or covered sensor A dirty or covered sensor may hinder the detection of vehicles. ▷ If necessary, clean the radar sensor. Remove layers of snow and ice care ...