Resetting the system

Reset the system after each correction of the tire inflation pressure and after every tire or wheel change.

1. "Vehicle Info"
2. "Vehicle status"
3. 4. Start the engine - do not drive away. "Reset"
4. Start the engine - do not drive away.
5. Reset the tire pressure using "Reset".
6. Drive away.

The tires are shown in gray and "Resetting TPM..." is displayed.

After driving for a few minutes, the set tire inflation pressures are applied as set values. The resetting process is completed automatically during driving. The tires are shown in green and "TPM active" is shown on the Control Display.

The trip can be interrupted at any time. If you drive away again, the process resumes automatically.

If a flat tire is detected during a reset, all tires are displayed in yellow.

    See also:

    Locking separately
    The trunk lid can be locked separately with the switch in the front passenger glove compartment. ▷ Trunk lid secured, arrow 1. ▷ Trunk lid not secured, arrow 2. Slide the switch int ...

    General information
    Moving parts need to be broken in to adjust to each other. The following instructions will help achieve a long vehicle life and good economy. ...

    Calls with multiple parties
    General information You can switch between calls or connect two calls to a single conference call. These functions must be supported by the mobile phone and service provider. Accepting a call ...