General information

Lamps and bulbs make an essential contribution to vehicle safety.

The manufacturer of your vehicle recommends that you entrust corresponding procedures to your service center if you are unfamiliar with them or they are not described here.

You can obtain a selection of replacement bulbs at your service center.

Only change bulbs when they are cool; Danger of burns
Only change bulbs when they are cool; otherwise, there is the danger of getting burned.◀

When working on the lighting system, you Working on the lighting system
When working on the lighting system, you should always switch off the lights affected to prevent short circuits.

To avoid possible injury or equipment damage when replacing bulbs, observe any instructions provided by the bulb manufacturer.◀

Do not touch the glass of new bulbs with Do not touch the bulbs
Do not touch the glass of new bulbs with your bare hands, as even minute amounts of contamination will burn into the bulb's surface and reduce its service life.

Use a clean tissue, cloth or something similar, or hold the bulb by its base.◀

    See also:

    DSC OFF
    When DSC OFF, is active, driving stability is limited during acceleration and when driving in bends. ...

    Removing: manual head restraints
    Only remove the head restraint if no one will be sitting in the seat in question. 1. Pull the head restraint upward as far as possible. 2. Press the button, arrow 1, and pull the head restrain ...

    General information
    Overloading the vehicle To avoid exceeding the approved carrying capacity of the tires, never overload the vehicle. Overloading can lead to overheating and increases the rate at which damage de ...