Settings for the map view

The settings are stored for the remote control currently in use.

1. "Navigation"

2. "Map"

3. Open "Options".

4. "Settings"

5. To set the map view:

▷ "Day/night mode"
Select and create the necessary settings depending on the light conditions.
"Traffic conditions/gray map" active: the setting is disregarded.

▷ "Satellite images"
Depending on availability and resolution, satellite images are displayed at scales of approx. 1 mile to 600 miles/2 km to 1,000 km.
▷ "Perspective view in 3D"
Prominent areas that are contained in the navigation data are displayed on the map in 3D.
▷ "Traffic conditions/gray map"
The map is optimized for displaying traffic bulletins.
Symbols for the special destinations are no longer displayed.

    See also:

    Pairing/unpairing the mobile phone
    General information The following functions are available: ► Use of a mobile phone as a telephone. ► Use of a mobile phone as an additional telephone. ► Use of a mobile phone a ...

    Checking the pressure
    Only check the tire inflation pressure when the tires are cold. This means after driving no more than 1.25 miles/2 km or when the vehicle has been parked for at least 2 hours. When the tires are w ...

    Service data in the remote control
    Information on the required maintenance is continuously stored in the remote control. Your service center will read out this data and suggest the right array of service procedures for your vehic ...