Reassigning individual programs

1. Switch on the ignition.

2. Hold the hand-held transmitter at a distance of approx. 1 to 3 in/2.5 to 8 cm from the memory buttons.

The required distance depends on the particular hand-held transmitter.

3. Press the memory button of the integrated universal remote control.

4. If the LED flashes slowly after approx.

20 seconds, press the transmit button on the hand-held transmitter.

5. Release both buttons when the LED flashes rapidly.

If the LED does not flash rapidly after approx.

60 seconds, change the distance and repeat the step.

Canada: if the LED does not flash rapidly after approx. 60 seconds, change the distance and repeat the step. If programming was aborted by the hand-held transmitter, hold down the memory button and press and release the button on the hand-held transmitter several times for 2 seconds.

    See also:

    Replacing the batteries
    No rechargeable batteries Do not use rechargeable batteries, as damage may result from the substances in the batteries. 1. Remove the cover. Press on the cover, arrow 1, and push forward, ...

    At a glance
    1. Rear fog lamps 2. Front fog lamps 3. Automatic headlamp control, Adaptive Light Control , High-beam Assistant, Welcome lamps, daytime running lights 4. Lamps off, daytime running lights 5. ...

    Low tire pressure message
    The yellow warning lamp lights up. A Check Control message is displayed. ▷ There is a flat tire or a major loss in tire inflation pressure. ▷ The system was not reset after a wheel ...