Initialization

The initialization process adopts the set inflation tire pressures as reference values for the detection of a flat tire. Initialization is started by confirming the inflation pressures.

Do not initialize the system when driving with snow chains or with a compact wheel.

1. "Vehicle Info"

2. "Vehicle status"

3. 4. Start the engine - do not drive away. "Reset"

4. Start the engine - do not drive away.

5. Start the initialization with "Reset".

6. Drive away.

The initialization is completed while driving, which can be interrupted at any time.

The initialization automatically continues when driving resumes.

    See also:

    Glove compartment
    Front passenger side Opening Pull the handle. The light in the glove compartment switches on. Close the glove compartment again immediately Close the glove compartment immediately after use ...

    Switching off automatically
    The system switches off and the LED goes out: After approx. 160 ft/50 m when driving forward. Above approx. 22 mph/36 km/h when driving forward. Switch on the system again if necessary. ...

    Environmental conditions
    ▷ Say the commands, numbers, and letters smoothly and with normal volume, emphasis, and speed. ▷ Always say commands in the language of the voice activation system. ▷ When se ...