Avoiding unintentional alarms
The tilt alarm sensor and interior motion sensor can be switched off together, such as in the following situations:
▷ In duplex garages.
▷ During transport on car-carrying trains, at
sea or on a trailer.
▷ When animals are to remain in the vehicle.
Switching off the tilt alarm sensor and interior motion sensor
Press the button on the remote
control
twice in succession.
The indicator lamp lights up for approx. 2 seconds and then flashes continuously.
The tilt alarm sensor and interior motion sensor remain switched off until the vehicle is locked again.
See also:
Switch off any functions that are not currently needed
Functions such as seat heating and the rear window
defroster require a lot of energy and consume
additional fuel, especially in city and stopand-
go traffic.
Therefore, switch off these functio ...
Preparation
1. Check whether the battery of the other vehicle
has a voltage of 12 volts and approximately
the same capacitance in Ah. This information
can be found on the battery.
2. Switch off the engine ...
Programming
LED, arrow 1.
Memory buttons, arrow 2.
Fixed-code hand-held transmitters
1. Switch on the ignition.
2. Initial setup:
Press both outer buttons 1 and 3 for approx.
20 seconds until the L ...