Initializing after a power failure

After a power failure during the opening or closing process, the roof can only be operated to a limited extent.

Initializing the system

The system can be initialized when the vehicle is stationary and the engine is running.

Monitor the closing process and make Danger of pinching

Monitor the closing process and make sure that the closing path of the glass sunroof is clear; otherwise, injuries may result.

Press the switch up and hold it

Press the switch up and hold it until the initialization is complete:

  • Initialization begins within 15 seconds and is completed when the sunroof and sliding visor are completely closed.
  • The roof closes without pinch protection.
    See also:

    Radar sensors
    Radar sensors The radar sensors are located under the rear bumper. The system may not be fully functional in the following situations: ▷ Dirty or icy bumper. ▷ Stickers on the ...

    Malfunctions
    Steering wheel vibration Frequent activation of the steering wheel vibration causes the system to overheat. This causes Active Blind Spot Detection to become deactivated. Let the system cool an ...

    Opening and closing: Using the remote control
    Persons or animals in a parked vehicle could lock the doors from the inside. You should therefore take the remote control with you when you leave the vehicle so that the latter can be opened from ...