Storing

1. Switch on the ignition.

2. Set the desired position.

3. the Press the button. The LED in the button lights up.

4. 2. The LED Press the desired button 1 or 2. The LED goes out.

If the M button is pressed accidentally:

Press the button again.

The LED goes out.

    See also:

    High-beam Assistant
    The concept When the low beams are switched on, this system automatically switches the high beams on and off or suppresses the light in the areas that blind oncoming traffic. The procedure is cont ...

    New remote controls
    You can obtain new remote controls from your service center. ...

    1 Series M
    Rather than the single-turbo setup from the 135i, the 1 Series M gets a twin-turbo six-cylinder that's good for 335 hp and 332 pounds-feet of torque. In extreme situations, the 1 Series M can ente ...