Emergency detection of remote control
It is possible to switch on the ignition or start the engine in situations such as the following:
▷ Interference of radio transmission to remote control by external sources.
▷ Discharged battery in the remote control.
▷ Interference of radio transmission by mobile devices in close proximity to the remote control.
▷ Interference of radio transmission by charger while charging items such as mobile devices in the vehicle.
A Check Control message is displayed if an attempt is made to switch on the ignition or start the engine.
Starting the engine in case of emergency detection of remote control
Starting the engine in case of emergency detection of remote control
Automatic transmission: if a corresponding Check Control message appears, hold the remote control, as shown, against the marked area on the steering column and press the Start/Stop button within 10 seconds while pressing the brake.
Manual transmission: if a corresponding Check Control message appears, hold the remote control, as shown, against the marked area on the steering column and press the Start/Stop button within 10 seconds while pressing the clutch.
See also:
Disposing of old batteries
Have old
batteries disposed of by your
service center or bring them to a recycling
center.
Maintain the battery in an upright position for
transport and storage. Secure the battery so
that ...
Using the door lock
General information
Locking from the outside
Do not lock the vehicle from the outside if
there are people in it, as the vehicle cannot be
unlocked from inside without special knowledge.◄
...
Snap-in adapter
Installation position
In the center armrest. ...