Connecting headphones
You can connect headphones with a jack plug or operate them using the infrared interface.
To enable optimal use of the infrared interface, use infrared headphones that comply with the IEC 61603-2 standard.
Compatible infrared headphones and information about supported headphones are available at your service center.
When using infrared headphones, it is important not to interrupt the infrared connection between the headphones and the infrared interface. This means that no obstacle should come between the two and that the cover of the infrared interface should not be covered or scratched. Unfavorable lighting conditions such as glare from outside can interfere with reception.
See also:
Switching off automatically
The system switches off and the LED goes out:
▷ After approx. 33 ft/10 m when driving forward.
▷ After approx. 9 mph/15 km/h when driving
forward.
Switch on the system again if necess ...
Display on the Control Display
The traffic area to the left and right is displayed
on the Control Display.
Guidelines at the bottom of the image show the
position of the front of the vehicle.
Brightness
With the Side View ...
Bypassing a section of the route
Calculate a new route for a route section.
1. "Navigation".
2. "Route information".
3. "New route for"
4. Turn the controller. Enter the number of
miles within wh ...